- Empennage
- Wings
- Fuselage
- Assembly
- Firewall Forward
- Landing Gear
- Painting
- Weight And Balance
- Pre Flight
- Panel
- Interior
- Engine Building
- Wiring
|
Log Entries For Misc
| Date | Summary |
|
Sep 15, 2008
|
Changed the wiring for the fuel flow sensor, added plug and socket for oil temp probe.
|
|
Sep 8, 2008
|
Replaced I/O unit and installed shunt for current measurements.
|
|
Sep 6, 2008
|
Completed Magnetometer wiring at wing root
|
|
Jul 22, 2008
|
Got as much wiring as possible. Scott called and wants to get the fuselage for paint.
|
|
Jul 19, 2008
|
A little more wiring!!
|
|
Jul 15, 2008
|
A bit more wiring just have the ap and ah to go.
|
|
Jul 1, 2008
|
Installed molex connector for roll servo, completed and tightened all servo hardware to belcrank,
|
|
May 25, 2008
|
Started sub panel wiring, wired flap motor and flap vontrol board.
|
|
May 25, 2008
|
Wired engine ground and starting circuits, installed battery.
|
|
May 13, 2008
|
Installed DB-25 on Pilot stick wiring.
|
|
Mar 8, 2008
|
Wired AHRS system in rear fuselage
|
|
Jan 20, 2008
|
tried to polish panel will need to repaint. BUMMER.
|
|
Jan 13, 2008
|
primed and painted panel
|
|
Jan 8, 2008
|
Drilled more holes in panel a few more to go.
|
|
Jan 6, 2008
|
Layed out panel and punched and drilled will do switch layout later
|
|
Nov 26, 2007
|
Installed molex connector on aft deck for trim wiring
|
|
Nov 12, 2007
|
Installed Servo controler and relay, installed flap relay
|
|
Oct 22, 2007
|
installed pitch servo and strobe supply. Wired mains to strobe and installed pins for tail and wing strobes wiring.
|
|
Oct 21, 2007
|
Did some wiring in prep for riviting foreward top skin.
|
|
Sep 22, 2007
|
Finalized fuselage wiring installed wiring in conduit in center tunnel.
|
|
Aug 18, 2007
|
installed strobe to wing root wiring, Panel to AHRS wiring, Servo to panel and auto trim wiring
|
|
Aug 15, 2007
|
Pre wire aft fuselage, Pre wire servo, flaps, auto trim circuits
|
|
ExperCraft is supported by these quality vendors:
|